Cascade Crew

aaron_sK · Posted: Sat Sep 10, 2011 8:54 pm Post subject: Cast iron rear brakes

Got a wild hare to get this 9-bolt under the car so the 10 can go to the scrapyard and I can have one less thing in my shop that I am tripping over.

Unfortunately I scrapped the brakes off of it assuming I would be buying a kit, which is going to be a little further down the road. So I need cast iron calipers/rotors.pads. Not picky about condition as long as they are usable.

Can drive to you, or pay for shipping. Hit me up with price and what you have. Thanks.

Xophertony · Posted: Sun Sep 11, 2011 8:59 am Post subject:

i have drums off a ten-bolt. I have everything. you can have it all.. as long as you take the rear end they are attached to. i want this thing out of my yard.

-Tony

aaron_sK · Posted: Sun Sep 11, 2011 9:56 am Post subject:

Disk brakes, Tony. Wink

I have a 10-bolt with drums on the car now, and a 9-bolt on the floor of the shop with backing plates for the older-style disk brakes.

Al Hasse · Posted: Sun Sep 11, 2011 10:28 am Post subject:

If you can figure out how to re-drill them for the 9-bolt, I have a set of backing plates for the PBR disc brakes that you can have.

Xophertony · Posted: Tue Sep 13, 2011 5:26 pm Post subject:

sucks, i just scrapped a car with a nine bolt and discs.. rear end was to rusty to even undo bolts.. but i bet i could have gotten the brakes off.

well, such is life

Twilightoptics · Posted: Tue Sep 13, 2011 6:42 pm Post subject:

Same deal... I have a disc brake setup off of a 10 bolt....

aaron_sK · Posted: Tue Sep 13, 2011 7:05 pm Post subject:

I have the backing plates, Paul. I just need the calipers and rotors.

Twilightoptics · Posted: Tue Sep 13, 2011 9:01 pm Post subject:

Do they run the 10bolt style caliper? If so..... we can make a deal :O)

aaron_sK · Posted: Tue Sep 13, 2011 9:22 pm Post subject:

TGO idiots seem to think so.

Only one real way to find out.

Al Hasse · Posted: Tue Sep 13, 2011 9:36 pm Post subject:

IIRC, Jake has them on his 9-bolt.