| View previous topic :: View next topic |
| Author |
Message |
HONDASLAYER Member

Joined: 17 Mar 2009 Posts: 444 Location: VANCOUVER WA.
|
Posted: Tue Aug 04, 2009 8:06 pm Post subject: Paint prep Questions |
|
|
I have a couple of questions: How do i remove the chrome trim peices that run along the sides of my maro? How do i get the paint off of my front and rear bumpers? How do I know exactly where to put racing stripes? Do i need to remove my rear finn, and if so; I know how to take off the hatch part but can't see how to get the sides off. And is there anything else i might need to know? Other than Tapeing off and masking and stuff..  _________________
<div>Quizzes Girls Games</div> |
|
| Back to top |
|
 |
Al Hasse Member

Joined: 19 Nov 2005 Posts: 4379 Location: Bremerton, WA
1992 Chevrolet Camaro RS
|
Posted: Tue Aug 04, 2009 8:20 pm Post subject: Re: Paint prep Questions |
|
|
| HONDASLAYER wrote: | | I know how to take off the hatch part but can't see how to get the sides off. |
They are held on with nuts on the inside of the quarter panel. Access the driver side by going behind the storage compartment, the nuts should be just forward of the tail light. Same for the passenger side by going through the spare tire storage area. _________________ 92 Camaro
89 Camaro
 |
|
| Back to top |
|
 |
83Z28BlackBetty Bam-Ba-Lam

Joined: 13 Mar 2006 Posts: 2083 Location: Aloha
1983 Chevrolet Camaro Z/28
|
Posted: Wed Aug 05, 2009 11:00 am Post subject: |
|
|
Stripes on hood for example:
start at the front and measure how wide the hood is
divide that number by 2 and get the center point
figure out how far apart you want your stripes (mine are 3 in apart i think)
take that number and also divide it by 2 (1.5" ) and measure that on each side of center point.
do the same thing for multiple points down the hood and then just line up the dots for the inside lines.
Then figure out how wide you want your stripes to be and do the same thing. Just keep measuring from the center point to make sure they are consistent.
Trust me, It is a PAIN IN THE A$$ but worth it.
oh, and mine are not one consistant width on the front. they start narrow and widen with the hood as they go back, i just followed the lines on the hood for that part.
feel free to ask more if need be
~JAKE _________________ 1983 Z-28 5.7 LT1, T56, Headman headers, BW 9 Bolt Posi Disc, WS6 suspension
 |
|
| Back to top |
|
 |
|