Cascade Crew Forum Index Cascade Crew
Message Forums
 
 GarageGarage   1/4 Mile Table1/4 Mile Table   FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Rodney's Rod Ends

 
Post new topic   Reply to topic    Cascade Crew Forum Index -> Back Porch
View previous topic :: View next topic  
Author Message
Twilightoptics
Hardcore (12sec Club)


Joined: 13 Jan 2004
Posts: 9191
Location: Auburn , WA

1987 Chevrolet Camaro IROC-Z
PostPosted: Wed May 24, 2006 9:02 am    Post subject: Rodney's Rod Ends Reply with quote
Hey Rod... you've done stuff with rod ends....

How do I get


To look like

With the spacer deal in the center for LCA's? IF it's just a piece of steel, wont it slide back and forth on there?
Back to top
View user's profile Send private message Send e-mail AIM Address MSN Messenger
rjmcgee
The Hammer


Joined: 08 Jan 2004
Posts: 2328
PostPosted: Wed May 24, 2006 11:18 am    Post subject: Reply with quote
What is the hole diameter on the rod end that you have Paul?

The LCA bolts are probably 12 or 13 mm in diamerter. If you had a 3/4" rod end then it would be pretty simple to make a press in bushing the same width as the stock LCA rubber bushing to eliminate any side to side motion.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Cascade Crew Forum Index -> Back Porch All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group