| View previous topic :: View next topic |
| Author |
Message |
GREG DAVIDSON Member

Joined: 15 Mar 2008 Posts: 1159 Location: Salem
1989 Pontiac Formula
|
Posted: Tue Sep 07, 2010 1:05 am Post subject: Hatch pull down |
|
|
| Could someone please send me or post up a pic of the wiring for the hatch pull down. Mine quit working a while back and i pulled my plastic panels off to check out the wires. What i found was a ball of wires covered in electrical tape extremely hot and had melted allot of the tape. I pulled the tape and found a melted plastic resister housing. Now is that resistor supposed to be there ? And there where 3 wires hooked to it. If its suppose to be there what size should i use to put back in ? I'd like to get my hatch to seal before this nice pacific Northwest Winter hits... I'll post a pic tomorrow.. |
|
| Back to top |
|
 |
Al Hasse Member

Joined: 19 Nov 2005 Posts: 4379 Location: Bremerton, WA
1992 Chevrolet Camaro RS
|
Posted: Tue Sep 07, 2010 5:26 pm Post subject: |
|
|
This might help _________________ 92 Camaro
89 Camaro
 |
|
| Back to top |
|
 |
|