Cascade Crew

Twilightoptics

So I'm not ready to take mine out yet... but could someone please measure the width of the metal spacer inside the bearing that the bolt goes through? I need both the inside diameter, and how long it is.

Thanks
-P

Dewey316 · Posted: Tue Oct 24, 2006 8:18 pm Post subject:

My spare Spohn arm, measures 2 3/8"

Near as my handy tape measure reads, I show in ID as 1/2"

Twilightoptics · Posted: Tue Oct 24, 2006 8:24 pm Post subject:

Danke

Dewey316 · Posted: Tue Oct 24, 2006 8:28 pm Post subject:

Schultzy89GTA · Posted: Tue Oct 24, 2006 8:55 pm Post subject:

Paully,
Were you wanting stock LCA dimensions? Not sure about Dewey's but the bolts for my Spohn LCA's were larger diameter than stock.

-Schultzy

Dewey316 · Posted: Tue Oct 24, 2006 8:57 pm Post subject:

Stock might have been metric, maybe 12mm. I can't recall if the spohns came with diffrent hardware or not.

Twilightoptics · Posted: Tue Oct 24, 2006 9:49 pm Post subject:

1/2" works fine. I can't always upgrade the bolt if I need to. My bolts are factory so : Shrug

: My aluminum pipe is 1/2" :OP

Xophertony · Posted: Wed Oct 25, 2006 12:27 am Post subject:

83Z28BlackBetty · Posted: Wed Oct 25, 2006 1:20 am Post subject:

83Z28BlackBetty · Posted: Wed Oct 25, 2006 1:21 am Post subject:

Quasi-Traction · Posted: Wed Oct 25, 2006 6:30 pm Post subject:

looks like his aluminum TIG classes will come into real world aplication....

Twilightoptics · Posted: Wed Oct 25, 2006 9:00 pm Post subject:

Xophertony · Posted: Wed Oct 25, 2006 10:26 pm Post subject:

are you going to thread the ends and use heim(sp) joints?

Twilightoptics · Posted: Thu Oct 26, 2006 9:34 am Post subject:

Got a tube that is already threaded.