Cascade Crew

Wolffy · Member Joined: 22 Jan 2004 Posts: 375 Location: Spokane

well after 3-4 weeks of working on my iroc trying to get her ready for cows i finally got her back on the ground tonight, i need to have the front end checked out, there's something wrong i can tell, but not sure what yet.

heres my laundry list of things ive been doing

swapped from drum to disc rear end (found out the shop that setup the rear end didnt put any fluid in it tonight, i think i got lucky & didnt burn it)
also installed the LCA's from Mike

swapped in a 145 speedo & the gears in the tranny for it

installed my HSR

installed the NOS system

installed the 58mm TB

installed the B&M megashifter

installed a Lokar shift indicator, cause the B&M indicator is a POS

installed my TGO hood

almost done fabricating a new console plate for the B&M & the shift indicator

fabricated a mouting plate for the NOS activation solenoid (yours is ready unca, bringing it with me)

finally got the right prop valve installed & the brakes bleed

i still need to get the following done

interior installed, almost done painting it all, thanxs Paul for the paint idea

make & get powder coated & install a 4 point roll bar, so i can install the 4 point seat belts

get the front windows tinted

pick up some dual lock (its like velcro) so i can install front & back blackouts (thanxs again Paul for the rear ones)

pickup & install a new steering wheel

try to tune the computer some

sand & primer the hood

install the door pins from andyz28, they are nice, greasable too

fill the NOS bottle

i think thats about it for now

i just ordered some new door panel backs, so i can finish the custom interior thats in progress

Schultzy89GTA · Posted: Sat May 21, 2005 9:39 pm Post subject:

Awesome Wolfy! Sounds like you are making up time quickly. I look forward to seeing you and the Z at Cows.

-Schultzy