Cascade Crew

Hey everyone, I haven't been on this forum in a while. I am selling my 85 Z28 with a 383 stroker, Vortec Heads, TH350, Richmond 4.10 gears, Edelbrock 750CFM carb, MSD Ignition and more. I have not dri ...

Hey everyone, It's been a while since I last posted, been busy with school. Does anyone know what backspacing to use for a 15x10 wheel and does anyone have recomendations for a tire?

If you are still using the factory u-joint, you have to heat them with a torch to remove them from the driveline. I had to change mine a week ago.

My fan is wired to turn on when the ignition is on.

I usually let my friends and family (who know how to drive a manual) drive my 4Runner. When it comes to the camaro, my step dad is the only person that can drive it because he helped me build it. I w ...

Your transmission should be fine. My friend runs nittos on his fox body mustang with a stock 5 speed and 347 stroker. He has never had any problems.

The first few times I went to PIR I had too much rubber hose coming off my hard lines. All I got was a warning and told to fix it for next time.

My friends and I use to throw sauce from fast food restaurants at both cars and people only a few years ago. It occured all throughout our high school and no one made a big deal out of it. I came out ...

What time is everyone heading over. I am going over when the gates open.

That is the same IROC that is used in Gran Turismo 4 on PS2.

I went with Spohn's cheapest LCA.

I just recieved my rear lower control arms and relocation brackets from spohn. Has any one else used relocation brackets?

I would enter if I was back in Pullman. I won't be back to the east side until August.

I've been thinking of replacing all the gauges with autometer. I don't trust the factory gauges.

I think the temp gauge was the problem the whole time. I hooked up a digital temp gauge between the thermostat housing and the rad hose, and the highest temp reached was 184*.

Any of those two days are good for me. I should have everything tuned by then.

I have a single electric fan and it is hooked up to stay on all the time and it is running.

I don't have an air dam on the car, but before the car never overheated with out it.

I picked up a new ...

The thermostat is a 195*, same as the one I had before and made sure I put it in the right way.

The lower rad hose might be the problem. I did some more researching and discovered that the lower r ...

Today I went out and fired the camaro up to get everything tuned since i replace the head gasket. After running about five minutes, I noticed the engine getting hot. I looked at the temp gauge and it ...

My camaro is legal once again. I've been trying to pass emissions, but there was no way it would pass. I realized that Pullman doesn't have emissions laws, so i registered the car to my address there. ...